Seed & Fertilizer Bulk Handler
REAR DISCHARGE-LARGE SIZE 15 cu. metre capacity (13.5 tonne)
Click on a thumbnail to view a larger & clearer image.
CONSTRUCTION
As with all our tray mounted bins, this twin hopper bin is built within a high tensile square tube (RHS) framework. The base is designed to sit flat on the truck tray within the side rails. The unique shape features the top section peaked toward the centre allowing for a lower centre of gravity by preventing filling one side only.
DIMENSIONS & CAPACITY
Overall length is 6.05 metres, length of the base frame which sits on the tray is 4.17 metres, the width is 2.3 metres and the overall height is 2.2 metres. Capacity is equivalent to approx. 6 tonnes of wheat and 7.5 tonnes of DAP. The divider wall can be custom fitted at the time of manufacture to suit larger or smaller capacities in each compartment. Your truck will need to handle a 15 tonne load if you select this size bin.
FEATURES
A full length, one piece peaked steel lid provides a permanent weather-proof cover which is opened at the rear from the ground with the easy operation of a single lever which can be hooked out of the way when the lid is closed. When open, the lid rests to one side clear of any filling device, auger, conveyor etc., the filling width opening is 900 mm wide. Turnbuckles (16 mm) and chains are provided at each corner of the bin to ensure secure and safe attachment to the truck. Adjustable jacking points are also provided for raising or lowering the bin for loading. An external ladder with fold down lower section is provided as well as internal access rungs and handles in each compartment.
DRIVE SYSTEM
A simple drive system allows the use of a relatively low powered engine with reduction gearbox. The very reliable 6 HP Vanguard motor coupled directly to a hefty American made gearbox does an excellent job. The engine is mounted at the side for easy access. Each auger is driven by its own belt from the motor. The drive is engaged when the operator pulls a rope and hooks a pre-set knot in a quick release keyhole retainer.
DISCHARGE SYSTEM
The twin 150mm augers extend out the rear of the bin on the right hand corner. Telescopic PVC tubes and a flexible coupling attached to the end of each auger enable the operator to direct the seed and fertilizer flow to the required bin on the seeder. Flow into each auger can be controlled by the operator through a lever which connects to a slide at the inlet of each auger. The augers can be cleared after each operation or stopped and left ready to go next fill.
OPERATION
With the bin reversed into position the motor is started when the chutes are directed to the appropriate hoppers on the seeded the drive can be engaged by the rope control mentioned previously. With the sliding inlet control open seed and fertilizer is conveyed to the seeder. When the hopper is full the drive can be released and the flow will be stopped immediately.
The rear discharge can sometimes be more suitable than the side discharge type particularly for mid mounted air seeder hoppers, it can also be more suited in situations where turning space and access to the planting machine is limited.
STORAGE
Optional "A" frame legs can be supplied to facilitate easy and safe removal and storage, preferably under cover. Thorough cleaning is recommended especially any build up of fertilizer.
